Gage Bilt GB715 Kurulum Kılavuzu - Sayfa 12

Perçin Aletleri Gage Bilt GB715 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Gage Bilt GB715 17 sayfaları.
Ayrıca Gage Bilt GB715 için: Orijinal Talimat Kılavuzu (20 sayfalar)

Sayfayı Yazdır
Gage Bilt GB715 Kurulum Kılavuzu
WARNING:
Only qualified and trained personnel should perform overhaul.
WARNING:
Personnel must read and understand all warnings and cautions.
WARNING:
Tool must be maintained in a safe working condition at all times and examined on a daily basis for damage or
wear. Any repair should be done by qualified personnel trained on Gage Bilt procedures.
WARNING:
Disconnect tool from its power source before performing overhaul. Severe personal injury may occur if power
source is not disconnected.
WARNING:
Excessive contact with hydraulic oil and lubricants should be avoided (See SDS documents for all
applicable materials
WARNING:
When operating, repairing or overhauling tool, wear approved eye protection. Do not look in front of tool or
rear of tool when installing fastener.
WARNING:
Use only Gage Bilt hydraulic hoses and couplings, or equivalent, rated for 10,000 psi. working pressure.
WARNING:
Ensure air hose is securely connected to avoid possible hose whipping (Air Actuated Tools only).
WARNING:
Depress air actuator assy and disconnect from air, with the piston in the rear position, before overhaul.
Severe personal injury may occur if air hose is not disconnected.
rod assy downward with head cylinder removed. Hydraulic oil will eject forcibly from handle assy.
Note:
Dispose of hydraulic oil in accordance with manufacture safety datasheet.
All tool materials are recyclable except rubber o'rings, seals and wipers.
Perform overhaul in a clean, well lit area using care not to scratch or nick any smooth surface that comes in contact with an o'ring. Use of
Lubriplate® (Gage Bilt part no. 402723) or other lubricant is recommended during reassembly to prevent tearing or distorting of o'rings.
The disassembly and re-assembly procedure can be accomplished by utilizing the following instructions and drawings. Use extreme care dur-
ing disassembly and re-assembly not to mar or nick any smooth surface that comes in contact with seals. Before installing seals, always apply
a good lubricant, such as Lubriplate, to the surfaces. It is recommended that tool kit (GB704TK) be used to facilitate overhaul (See pg 16). A
complete overhaul can be achieved by the use of Service Kit (715017) which contains a complete set of o'rings, back-up rings, screws, washers
and gasket.
Clean parts in mineral spirits or other o'ring compatible solvent being sure to clean o'ring grooves. Inspect components for scoring,
excessive wear or damage.
GB715 S/N: 1242 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

OVERHAUL

).
12
USE CAUTION
when forcing piston
REV. 2/16