Gage Bilt GB722 Kurulum Kılavuzu - Sayfa 5
Perçin Aletleri Gage Bilt GB722 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Gage Bilt GB722 13 sayfaları. Installation tool
Ayrıca Gage Bilt GB722 için: Orijinal Talimat Kılavuzu (20 sayfalar), Orijinal Talimat Kılavuzu (20 sayfalar)
Sayfayı Yazdır
HOW TO USE THE GB722
WARNING:
Operator
WARNING:
It is required that eye protection and hearing protection be worn during operation.
WARNING:
Do not pull rivet in the air. Personal injury from fastener ejecting may occur.
WARNING:
Air is exhausted from the bottom of the too. Direct bottom of the tool (exhausted air) away from
operator, other persons working in the vicinity, foreign matter and liquid.
CAUTION:
Do not use beyond the design intent.
The tool is shipped with a plastic plug in the air inlet connector. The connector has a 1/4-18 female pipe thread to accept
end-user air hose fitting.
1. Remove plastic shipping plug from Swivel (A-249) and screw in your air fitting.
2. Attach Deflector (752122) to rear of Head Cylinder Assy (752119).
WARNING:
Rotate deflector away from operator and other persons working in the vicinity.
3. Connect air hose to tool (3/8 minimum diameter air line is mandatory, 90 p.s.i. (6.2 bar) is recommended) and cycle
tool a few times by depressing and releasing air actuator assy. (Clean dry air is recommended.)
WARNING:
Ensure air hose is securely connected to avoid possible hose whipping.
4. Disconnect air hose from tool.
5. Select proper Nose Assembly and attach securely to the tool.
6. Connect air supply.
7. Insert rivet into Nose Assembly and the application then depress air actuator assy. Upon releasing the air actuator
assy the stem will eject to the rear of the tool.
WARNING:
Always disconnect air supply when tool is not in use to prevent accidental start-up.
S/N: 1753 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
MUST
read and understand all warnings and cautions.
DEFLECTOR
RED
SHIPPING
PLUG
QUICK
DISCONNECT
FITTING
NOSE
HEAD
ASSEMBLY
CYLINDER
ASSY
AIR
ACTUATOR
ASSY
Image may not reflect
actual tool.
5
RIVET
WORK
REV. 1/15