Dyna-Glo RMC- 95C6 Kullanıcı El Kitabı - Sayfa 11

Isıtıcı Dyna-Glo RMC- 95C6 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dyna-Glo RMC- 95C6 18 sayfaları. Portable kerosene-heater
Ayrıca Dyna-Glo RMC- 95C6 için: Kullanıcı El Kitabı (18 sayfalar)

Sayfayı Yazdır

. Remove the four wing nuts

which hold the wick assembly

to the heater and carefully lift

the wick assembly from the

heater.

. Remove the wick by

folding it to the inside.

Then remove the wick

sleeve from the bottom of

the assembly.

NOTE : DO NOT DISASSEMBLE THE STAINLESS STEEL WICK HOLDER.

. Line up the pins with the slotted holes inside the wick adjuster. Then

lightly press each of the three pins of the wick (now attached to the wick

sleeve) toward the center, away from the slanted grooves of the wick

adjuster allowing the wick do drop slightly. Once the pins line up with

each hole, press firmly on each pin toward the slanted grooves securely

through each hole.

NOTE : Turn the wick adjustment knob and check to be sure that the wick

moves up and down freely.

. The wick height will automatically be set to the correct burning height of

3/8" (10mm).

NOTE : Be sure to check wick height. It should be 3/8".

. Replace the wick adjustment knob temporarily.

Turn the knob CLOCKWISE to raise the wick.

. Hold the wick assembly up-side-

down, using caution, grasp the

wick cover firmly PULL it off with a

sharp tug. If you have difficulty

doing so, try loosening the wick

cover with a flat blade screwdriver.

C A U T I O N : The inside of wick

cover has sharp teeth. The use of

work gloves is suggested to avoid

injury.

. Install the new wick and

insert the 3 pins on a new

wick into the 3 holes on

the wick sleeve in the

upward direction. (See the

arrow marked " up" on

the wick sleeve)

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

. Push the new wick into the

retainer teeth of the wick

sleeve so that the wick

adheres tightly around the

inside of the wick sleeve,

smoothing out any wrinkles.

Hole

7/32 in. (5.5mm) All around

RIM OF WICK

ADJUSTER

(holder)

Wick Cover

WICK 25/64 IN. (10 mm)