Dawn 5036 Montaj ve Kullanım Kılavuzu - Sayfa 14

Çiftlik Ekipmanları Dawn 5036 için çevrimiçi göz atın veya pdf Montaj ve Kullanım Kılavuzu indirin. Dawn 5036 19 sayfaları.

Sayfayı Yazdır

REFLEX CENTER MANIFOLD ASSEMBLY (12.1)

PRESSURE

RETURN

TO ROW UNITS

Select a location to install the center manifold, ideally

between the two center rows.

Plumb the pressure and return trunk lines to the

indicated ports.

Route your row-to-row hoses from the center manifold

directly to the actuators as shown in fig. xxx. Ensure

hoses do not get crossed during install. Marking the

pressure and return hoses before installation is

recommended for ease of identification.

TRUNK HOSES (12.2)

Route ½" hose down draft arms allowing enough hose

for all folding points. Cut hose to length and crimp

supplied fittings to manufacturer specifications.

HOSES SHOULD BE CRIMPED AT YOUR

IMPLEMENT DEALER WITH THE PROPER

DAWN does not accept liability for

Hydraulic Components

91198 –

ADAPTER, -8 JIC

ELBOW

UPLIFT

PRESSURE

PARKER HOSE CRIMPER.

improperly crimped hoses.

SYSTEM OPERATING

PRESSURE GAUGE

91157 –

ADAPTER, -10

ORB -8 JIC

CLOSE VALVE TO OPERATE

REFLEX SYSTEM

ROW-TO-ROW HOSE ROUTING (12.3)

Starting for the center manifold, route hoses from the

corresponding RETURN, PRESSURE & UPLIFT

adapters to the row unit actuators. Continue along

toolbar to final rows.

Check clearance with seed tubes and vacuum lines to

prevent unnecessary wear. It is advisable to have

hydraulic hoses routed under any other tubes many

times. It may be necessary to alter the angle of the

adapters in the actuators to clear obstacles.

The first and final row actuators will require the

adapters to be replaced with supplied -8 ORB Hex

Hollow Plugs (PN 9533)

WING HOSES (12.3)

Route wing hoses from outer row units on center

section, around the folding point, to the first row unit

on wing, ensuring enough slack to fold and unfold

without being stretched or pinched. Many times, it is

helpful to do this routing with the toolbar half unfolded

to visualize the routing.

www.dawnequipment.com

20 MICRON FILTER

(REPLACE EVERY 3 YRS.)

UPLIFT OPERATING

PRESSURE GAUGE

91197 –

ADAPTER, -8 ORB

-8 ORFS 45 DEG

ADJUST VALVE TO UPLIFT

PRESSURE

NOTE: Pressure

and return routing

may be

interchanged if

necessary, but

ensure uniformity

throughout the

system. Valve

cables will need to

match hose

routing.

Toll Free: 800.554.0007

Fax:815.899.3663