Dawn 5036 Montaj ve Kullanım Kılavuzu - Sayfa 18

Çiftlik Ekipmanları Dawn 5036 için çevrimiçi göz atın veya pdf Montaj ve Kullanım Kılavuzu indirin. Dawn 5036 19 sayfaları.

TIPS USING UPLIFT ASSIST (14.5a)

1. Observe the Applied Pressure during operation.

•

If the average applied pressure in

operation is less than 500 psi, increase

the uplift pressure. (Large accumulator

on the row unit actuator is pre-charged

to 500 psi, and causes instability if

running at too low applied downforce).

2. Observe the Gauge Wheel Load in operation.

•

If the actual gauge wheel load is much

higher that the set target, increase the

uplift pressure.

3. If an area is known to be wet or soft, increase

uplift pressure to counter the weight of the row

unit.

Always ensure that system pressure

WARNING!:

has been relieved before opening any hydraulic

component!

KEY TERMS:

1:Automatic Mode – targets the user-set gauge

wheel load and applies/relieves pressure to

continuously maintain that load.

2. Manual Mode – Bypasses the gauge wheel

load and applies/relieves based on manually

entered pressure setting.

3. Gauge Wheel Load – Pressure from gauge

wheels measured by sensor at base of height

adjust assembly.

4. Applied Down Pressure – Pressure being

applied to row unit, either by automatically

adjusting to target gauge wheel load, or by

manually entering a set pressure.

Automatic mode is default setting in normal operating

conditions.

Reflex Operating System

www.dawnequipment.com

Toll Free: 800.554.0007

Fax:815.899.3663