5th Wheel TDR01Z Orijinal Talimat Kılavuzu - Sayfa 11

Bisiklet 5th Wheel TDR01Z için çevrimiçi göz atın veya pdf Orijinal Talimat Kılavuzu indirin. 5th Wheel TDR01Z 13 sayfaları.

Check the chain

Loosen the rear axle nut ﬁrst, and then turn left or right to adjust the chain drawing nut to correct the

slack of the chain. When adjusting the chain, align the front and rear sprockets to form a straight line.

After adjustment, re-ﬁx the rear axle nut and lock the drawing nut to make the upper and lower

movable distance of the loose side of the chain at the midpoint of the two sprockets reach

10mm - 15mm.

10-15mm

12. Use & Maintenance of Controller and Motor

Usage and Maintenance of Controller

• Regularly check whether the ﬁxing screws and wiring of the controller are loose.

• Regularly clean the dust on the controller surface, which is conducive to heat dissipation. It is forbidden to

wash the electrical components with water to avoid the danger of electrical short-circuit fault;

• It is strictly forbidden to modify the controller circuit without permission;

• Regularly check controller wiring and fuses, etc;

• In case of any abnormality in the controller, stop running immediately and send it to the Infanti dealer or

after-sales service for inspection and maintenance.

Motor installation and maintenance

• Regularly check whether the end cap screws on both sides of the motor are loose.

• Regularly check whether the motor wiring is loose, whether the appearance is deformed, and whether the

motor phase wire is damaged.

• For use in rainy days, the motor cannot be driven in deep water, and the water surface cannot exceed the

position of the rear axle.

• The hub of the motor cannot be violently impacted, the motor cannot be forced to run under the condition

of locked rotor, and overloading of the motor is strictly prohibited.

• If the motor is found to be running abnormally, stop the movement immediately, and check and repair it in

the Invanti dealer or after-sales point.

• Disconnect the power supply of the E-bike before cleaning. Do not touch the

live parts with wet hands or metal conductors, such as battery charging/

discharging port;

Note for

• Do not rinse the electrical components with water, but wipe the E-bike

appearance with a wet towel after drying it;

water washing

• Avoid rinsing the charging socket, wiring harness connectors and fuses

with water. Do not directly splash water on the storage box;

• Do not splash water directly on the brake, motor and front and rear axles

to prevent water from aﬀecting the service life of the E-bike components;

• Do not wash the E-bike with steam or high pressure water.