Dyna-Glo WK95C6C Kullanıcı El Kitabı - Sayfa 7

Isıtıcı Dyna-Glo WK95C6C için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dyna-Glo WK95C6C 18 sayfaları. Portable kerosene-heater

AUTOMATIC IGNITION SYSTEM

For safety and convenience, this heater features an automatic ignition system.

2 "C" cell batteries, included with the heater, provide the power for the igniter which lights the wick once it has

been raised to its maximum height.

To use the automatic ignition system:

Make sure the batteries have been installed.

Turn the wick adjuster knob clockwise until the wick has been raised to its maximum height. (Fig.12)

Push the ignition lever (Fig.13) to bring the glowing igniter into contact with the wick.

This will cause ignition to occur.

As soon as you see that the wick has been lit, release the ignition lever. This will automatically lower

the burn chamber back down over the wick.

Rotate the burner knob from side to side a few times to make sure that the burner is positioned

properly on the wick adjuster.

Then begin following the steps outlined in "Adjusting the wick" (page 7)

IGNITION VIA MATCH

If you encounter a problem with the ignition mechanism, or if you have dead

batteries, it is possible to light the heater with a match. (Fig.14)

The procedure is as follows:

Turn the wick adjuster knob clockwise until the wick has been

raised to its maximum height.

Lift the burn chamber by using the burner knob.

Touch a lighted match to the exposed top edge of the wick.

Once you see that the wick has been lit, lower the burn chamber back down over the wick.

Rotate the burner knob from side to side a few times to make sure that the burner is positioned

properly on the wick adjuster.

Then begin following the steps outined in "Adjusting the wick" (page 7)

CAUTION : Make sure that you do not leave the match, or any portion of it (match head, etc.) in the burner

area. Debris left from the match can cause an uneven alignment of the burner and may result in

smoke, incomplete combustion, odor, or fire.

WICK

FlLAMENT

IGNITER

1~2mm

g i

1 .

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

g i

1 .

Fig.14

Match