Active Silicon HARRIER 3G-SDI CAMERA INTERFACE BOARD Hızlı Başlangıç Kılavuzu - Sayfa 3
Bilgisayar Donanımı Active Silicon HARRIER 3G-SDI CAMERA INTERFACE BOARD için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Active Silicon HARRIER 3G-SDI CAMERA INTERFACE BOARD 8 sayfaları.
Sayfayı Yazdır
Harrier Evaluation Board Overview
Figure 6: Harrier Evaluation Board diagram
The Harrier Evaluation Board connects to the camera interface board using the supplied cable kit.
•
I/O (J102) - 4-way cable (connects to interface board J2).
•
Power/control, RS-232 (J103) - 9-way cable (connects to interface board J3).
•
JTAG (J104) - white 8-way cable (connects to interface board J4, not required for
The board is powered by the 12V power supply via a barrel connector (J306). This supply is also
used as a power supply for the camera and is connected to the camera via the Power Switch
(SW302). When the Power Switch (and camera power supply) is switched ON the PWR ON LED will
illuminate.
For more information please see the
(see Harrier 3G-SDI Camera Interface Board Evaluation Kit - Downloads section).
September 2020
HARRIER 3G-SDI CAMERA INTERFACE BOARD
normal use).
Harrier Evaluation Board datasheet
QUICK START GUIDE
Version 1.2.AS - September 2020
on the
Active Silicon website
Page 3 of 8