Dyna-Glo RMC-55R7B Kullanıcı El Kitabı - Sayfa 12

Gazlı Isıtıcı Dyna-Glo RMC-55R7B için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dyna-Glo RMC-55R7B 20 sayfaları. Portable kerosene heater
Ayrıca Dyna-Glo RMC-55R7B için: Kullanıcı El Kitabı (20 sayfalar)

Sayfayı Yazdır

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING

Replacement wick has a

black line.

Fold the new wick and slide it

into the holder.

Step 10

It is recommended to reinstall

the wick adjusting knob for

easier assembling.

Step 13

Snug 4 wing nuts on the

mounting stud, but do not

tighten.

Step 16

Check for correct clearance

between wick holder and draft

tube. It should be the same all

around.

Step 19

The black line on the outside of

the wick should match the top

edge of the holder.

Then press it against the teeth

inside the holder to obtain a

firm grip.

Insert the pinion at the other end of

the wick control shaft into top portion

of the rack of the wick holder.

This step can be easily carried out if

the wick holder is raised.

Step 14

Raise the wick to the full "up"

position, and evently tighten wing

nuts in several steps.

Check the function of safety

shut-off mechanism by pushing

the extinguish button to upset

the pendulum.

Step 20

Replace the wick and holder

in the burner tank.

Rotate 90 degrees left and

right as well as up and down

until the wick slides freely.

Check to see that gasket is

still in place on the burner tank.

e t

Slide the wick abjuster

assembly down the draft tube.

Position the adjuster shaft to

the front of the heater.

Check height of wick.

It should be 5/16 above collar.

e t

Reinstall the automatic ignition

assembly.

e t

Step 15

e t

Step 21