Aircommand 8100001 Kullanım Talimatları Kılavuzu - Sayfa 11
Klima Aircommand 8100001 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Aircommand 8100001 19 sayfaları.
Sayfayı Yazdır
Ibis 3 Owners Guide
COMMISSIONING OF THE UNIT
Turn the power on at the circuit breaker.
Using the remote control (Item #6) press the
Figure 17
ON/OFF button.
the remote control should be answered by a 'beep'
from the receiver in the plenum.
Figure 17 - Turn unit on
Press the MODE button until FAN mode is
Figure 18
selected.
Figure 18 - Select FAN mode
Press the FAN button to cycle through High –
Medium – Low fan speeds.
flow as the speeds change.
Figure 19 - Change fan speed
Revision V1
. Each command from
Figure 19
. Note air
Press MODE button until COOL is selected.
Figure 20
Figure 20 - Select COOL mode
Decrease the set point temperature below the
room temperature by pressing the
TEMPERATURE DOWN button.
compressor will start within three minutes. Run unit
until you can feel cool air from plenum outlets.
Figure 21 - Decrease SET POINT temperature
Note: Regardless of the mode selected there will
always be a delay before the compressor starts. This
delay is to protect the compressor and cannot be over
ridden.
Set mode to HEAT, and increase the set point
temperature above the room temperature.
22
. After the protection delay the compressor will
start.
Figure 22 - Change to HEAT mode and increase SET
Page 11 of 19
Figure 21
Figure
POINT
. The