Aircommand Sparrow Mk4 El Kitabı - Sayfa 15

Klima Aircommand Sparrow Mk4 için çevrimiçi göz atın veya pdf El Kitabı indirin. Aircommand Sparrow Mk4 17 sayfaları. Air conditioning unit
Ayrıca Aircommand Sparrow Mk4 için: Kullanıcı El Kitabı (17 sayfalar)

Sayfayı Yazdır

Operating instructions

Turn the unit on by pressing the ON/OFF button once.

Press the MODE button to cycle through options COOL, DRY,

HEAT and FAN. To select cooling, cycle mode button to

highlight COOL.

You may select either HIGH, MED, LOW or AUTO

FAN SPEEDS by pressing the FAN button. It is recommended

that you choose AUTO.

Now select the desired ROOM TEMPERATURE (herein referred

to as SETPOINT) by pressing the TEMP up or down buttons. The

readout will ﬂ ash the setpoint temperature. Keep pressing the

button until it ﬂ ashes your desired setpoint.

In approximately 5 seconds the display will resume reading

the ACTUAL room temperature.

The compressor will have a delayed start, usually 3 minutes

before the unit starts to cool.

NB: Any interruption to the power supply will cause the unit to

delay compressor start up.

For simply RECIRCULATING AIR, choose the FAN mode.

Choose any of the three fan speeds by pressing the FAN

button. NB: The temperature button is invalid in Fan only

mode.

To heat, press the MODE button to highlight HEAT.

Select the desired setpoint temperature by pressing the TEMP

buttons up or down.

It is recommended that AUTO fan speed be selected.

After the delay, the compressor will start.

Usually the fan will stop and will not re-energize until the heat

exchanger has warmed and then the fan will start to blow

warm air.

The DRY mode is used when the room temperature is close to

comfortable but you wish to dehumidify. Press the MODE

button to highlight DRY.

Set the temperature to the desired setpoint.

NB: The fan speed is locked in LOW.

The compressor will cycle on and off at approximate intervals

of 6 minutes to extract moisture from the air.

SLEEP MODE:

lf the unit is operating in COOL mode and the SLEEP button is

pressed to highlight the Sleep light, then the unit over the

next one hour will automatically raise the set point by 1oC.

Conversely in HEAT mode, the setpoint will be lowered 1oC.

TIMER:

The Timer may be used to turn the unit

ON or OFF in the next 24 hours.

Press the TIMER button once and the

display will ﬂ ash. Then within 3 seconds press the TIMER

button until you have set desired time to turn the unit OFF.

Another press of the timer button will allow the unit to be

programmed to turn ON.

LOCKING FUCTlON:

This provides a means of locking the MODE and FAN SPEED

setting.

To lock, press the TEMP down button simultaneously with the

MODE button. Hold for 3 seconds and the lock indicator will

light. To unlock repeat above procedure.

To change the readout from CENTIGRADE to FAHRENHEIT or

vice versa, press the TEMP down button simultaneously with

the FAN button.