Hi-Force HPS1000 Kullanım Talimatları Kılavuzu - Sayfa 5
Kaldırma Sistemleri Hi-Force HPS1000 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Hi-Force HPS1000 14 sayfaları. Single-acting, low height pad cylinders
Sayfayı Yazdır
Avoid damaging hydraulic hoses. ALWAYS route hoses to ensure that they are free from sharp
bends and kinks. Using a sharply bent or kinked hose will result in severe back-pressure, which can
lead to hose failure.
NEVER use a coupler/s to lift, carry or position a cylinder.
Servicing of hydraulic equipment must only be undertaken by a qualified technician.
DO NOT let familiarity gained with any hydraulic equipment allow you to become complacent.
Complacency with any equipment can result in a lack of discipline toward working guidelines and
safety principles.
DO NOT remove any labels from the product. Replace any damaged or unreadable labels
immediately.
2.4 Hydraulic Cylinder Specific Safety Precautions
DO NOT work under or near a load supported only by hydraulic means. A cylinder, when used as a
lifting device, should not be used as a load-holding device. Once lifted, all loads should be supported
using rigid mechanical structures.
NEVER exceed the maximum rated capacity of any hydraulic equipment. Hi-Force manufactures
HPS hydraulic cylinders to operate at a maximum working pressure of 700 bar (10,000 psi).
Overloading hydraulic cylinders can result in component failure and possible serious personal injury.
DO NOT connect a hydraulic pump with a higher pressure capacity rating to any Hi-Force cylinder
of this model series.
ALWAYS make sure that all equipment connected to the cylinder is in good working condition.
DO NOT weld any items to the cylinder unit or modify it in any way from its delivered condition. Your
warranty may be invalidated, and it could lead to serious personal injury.
NEVER attempt to connect or disconnect a tool / hose / component while the syste is under pressure.
NEVER leave a pressurised system unattended. If you must leave the area, release the pressure
and ensure the hydraulic relief valve on the pump is fully open.
DO NOT
drop or place heavy objects on a hydraulic hose, as this may cause
internal damage, which could result in rupture of the pressurised hose. A
ruptured hose could cause significant damage to components and possible
severe injury to personal operating nearby.
Failure to observe and obey the following safety precautions could result
in property damage, serious personal injury or death;
Operating Instruction Manual:
OM-HPS-01
5
Serial Numbers:
From: AF0316