Hi-Force HHP50 Çalıştırma ve Güvenlik Talimatları - Sayfa 3

Endüstriyel Ekipmanlar Hi-Force HHP50 için çevrimiçi göz atın veya pdf Çalıştırma ve Güvenlik Talimatları indirin. Hi-Force HHP50 4 sayfaları. Hydraulic hole punch

Sayfayı Yazdır

TDS1312

PREPARATION FOR USE

Refer to figure 2 for identification of parts.

Select the size of punch required based on the hole size that needs to be made

(Refer to Figure 1 for punch / die sizes).

Slacken the die retaining screw in the side of the anvil, and fit the die into the

recess with the identification spot upwards. Tighten the die retaining screw.

Unscrew and remove the locking collar using the tommy bar provided. Fit the

punch into the locking collar in the direction shown in figure 3.

Ensure that the identification spot on the punch is the same colour as that on

the die.

Figure 2. Component Identification (HHP30)

Figure 3. Punch assembly

Page 3 of 4

Rev 2. ECO No. 3890