Dynabrade 51395 Manuel

Sander Dynabrade 51395 için çevrimiçi göz atın veya pdf Manuel indirin. Dynabrade 51395 8 sayfaları. Up to 4500rpm

Sayfayı Yazdır

1hp Right-Angle Buffer/Polisher

Governor Controlled

Models:

51390 – 1,250 RPM, 5/8"-11

51391 – 1,800 RPM, 5/8"-11

51392 – 2,800 RPM, 5/8"-11

51393 – 4,500 RPM, 5/8"-11

51394 – 1,250 RPM, M14 x 2

51395 – 1,800 RPM, M14 x 2

51396 – 2,800 RPM, M14 x 2

51397 – 4,500 RPM, M14 x 2

Read and understand this tool manual before operating your air tool. Follow all safety rules for the protection of operating person-

nel as well as adjacent areas. Always operate, inspect and maintain this tool in accordance with the American National Safety

Institute (ANSI) Safety Code for Portable Air Tools – B186.1. For additional safety information, refer to Safety Requirements for the

Use, Care and Protection of Abrasive Wheels – ANSI B7.1, Code of Federal Regulation – CFR 29 Part 1910, European Committee for

Standards (EN) Hand Held Non-Electric Power Tools – Safety Requirements and applicable State and Local Regulations.

Read and understand tool manual before

work starts to reduce risk of injury to

operator, visitors, and tool.

Eye protection must be worn at all times,

eye protection to conform to ANSI Z87.1.

Respiratory protection to be used when exposed to

contaminants that exceed the applicable threshold

limit values required by law.

Carefully Read all instructions before operating or servicing any Dynabrade

Products offered by Dynabrade are not to be modified, converted or otherwise altered from the original design without expressed written

consent from Dynabrade, Inc.

Tool Intent: Right-Angle Buffer/Polishers are ideal for removal and polishing of materials using deburring, cleaning and polishing accessories.

Training: Proper care, maintenance, and storage of your tool will maximize their performance.

• Employer's Responsibility – Provide right-angle buffer/polisher operators with safety instructions and training for safe use of tools and accessories.

Accessory Selection:

• Abrasive/accessory RPM (speed) rating MUST be approved for AT LEAST the tool RPM rating.

• Before mounting an accessory, visually inspect for defects. Do not use defective accessories.

• Use only recommended accessories. See back page of manual and Dynabrade catalog.

• Follow tool specifications before choosing size and type of accessory.

• Only use recommended fittings and air line sizes. Air supply hoses and air hose assemblies must have a minimum working pressure rating of 150 PSIG

(10 Bars, g) or 150 percent of the maximum pressure produced in the system, whichever is higher. (See tool Machine Specifications table.)

Air Tool Manual – Safety, Operation and Maintenance

SAVE THIS DOCUMENT, EDUCATE ALL PERSONNEL

WARNING

SAFETY LEGEND

WARNING

SAFETY INSTRUCTIONS

Do Not Use Tool For Anything Other Than Its Intended Applications.

Parts Page Reorder No. PD03•27

WARNING

Practice safety requirements. Work alert,

have proper attire, and do not operate tools under

the influence of alcohol or drugs.

WARNING

Ear protection to be worn when exposure to sound,

exceeds the limits of applicable Federal, State or

local statues, ordinances and/or regulations.

WARNING

Air line hazard, pressurized supply lines and flexible

hoses can cause serious injury. Do not use dam-

aged, frayed or deteriorated air hoses and fittings.

Abrasive Power Tool.

Effective July, 2003