Active Storage ActiveSAN Hızlı Başlangıç Kılavuzu - Sayfa 4

Depolama Active Storage ActiveSAN için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Active Storage ActiveSAN 12 sayfaları.

ActiveSAN Management Software |

Mounting Your ActiveSAN

Once you have unboxed the ActiveSAN pair, check the packing list to ensure you have all the components

needed to complete the installation. Following the instructions in the rack mounting kit, mount the

ActiveSAN systems into a 4-post equipment rack. The rack must be a minimum of 28" in depth with a

maximum of 48"; deeper racks require rail extensions, contact your Reseller for more information.

The ActiveSAN appliances will accommodate square-hole or round-hole racks.

Pick a location in the rack that will allow adequate airflow in front and behind the appliances; they should

be stacked on each other or in close proximity to allow easy serviceability.

To install the system:

1) After removing ActiveSAN from box, remove protective plastic film from system and check to make certain all

components are properly seated. Locate the Rail Mounting Kit.

2) Slide inner rails onto ActiveSAN enclosure

with flat side against system and notched

end towards front.

4) Select one unit of space (1U) on rack,

adjust the outer rail length to fit rack.

6) Align inner rails on ActiveSAN with the outer

rails on rack; push system all the way into rack.

Quick Start Guide

3) Secure inner rails to ActiveSAN with inner

rail screws.

5) Secure front and rear of outer rails to 1U space

with alignment washers and mounting screws.

7) Secure ActiveSAN to rack with front bezel

screws usiing the shipped wrench.

Tighten snugly — do not over tighten.

ActiveSAN Management Software | Quick Start Guide 2011 - V.1