Hi-Link HLK-B30 Kullanıcı Kılavuzu - Sayfa 14

Kablosuz modüller Hi-Link HLK-B30 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Hi-Link HLK-B30 14 sayfaları. 802.11n+ble 4.2 wireless module

Sayfayı Yazdır

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

NOTE 1: This product has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This product generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this product does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

NOTE 1: Any changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE 2: Any modifications made to the module will void the Grant of Certification, this module is

limited to OEM installation only and must not be sold to end-users, end-user has no manual

instructions to remove or install the device, only software or operating procedure shall be placed in the

end-user operating manual of final products.

NOTE 3: The module may be operated only with the antenna with which it is authorized. Any antenna

that is of the same type and of equal or less directional gain as an antenna that is authorized with the

intentional radiator may be marketed with, and used with, that intentional radiator.

NOTE 4: For all products market in US, OEM has to limit the operation channels to CH1 to CH11 for

802.11b/g/n-HT20 and CH3 to CH9 for 802.11n-HT40 by supplied firmware programming tool. OEM

shall not supply any tool or info to the end-user regarding to Regulatory Domain change.