Great Little Trading Paddington Bunkbed L5481 Montaj - Sayfa 7
İç Mekan Mobilyaları Great Little Trading Paddington Bunkbed L5481 için çevrimiçi göz atın veya pdf Montaj indirin. Great Little Trading Paddington Bunkbed L5481 9 sayfaları.
Sayfayı Yazdır
IMPORTANT:
Two people are required from this point
forward.
#7
#7
#7
#5
#5
#5
STEP 5:
With one person supporting the first assembled bed end,
use the dowels to locate 1x rear guard rail (H) & back
side rail (J) in the postion as shown and insert 2x barrel
Hardware for Step 5
nuts (#7) into the large holes on the panels. Now insert
2x connecting bolts (#5) through the leg into the panels.
Keep finger tight at this stage.
4x #5 Connecting Bolts 70mm
Repeat these steps with the second bed end.
DO NOT FULLY TIGHTEN - Leave all bolts finger tight
4x #7 Barrel Nuts
at this stage to allow the next step to be completed
#5
#7
#7
H
J
Hardware for Step 6:
4x #5 Connecting Bolts 70mm
4x #7 Barrel Nuts
#5
STEP 6:
Carefully stand the bed on its feet.
With one person supporting the panel, take front side rail (G) and connect with
one bed end in the position as shown using the dowels. Insert 1x barrel nut (#7)
into the large hole on the side rail, then insert 1x connecting bolt (#5) through the
leg into the panel and tighten with your fingers.
Repeat at the other end of the front side rail (G) with the other bed end.
Now attach 2x front guard rails (I) to the bed ends above the side rail using 2x
barrel nuts (#7) and 2x connecting bolts (#5). FULLY TIGHTEN these bolts. One
person to support the unconnected ends if required.
Now go back and FULLY TIGHTEN all 8x bolts used in steps 5 & 6 using the Allen
key provided.
7
2x
I
I
#7
G
#7
#5
#5
#7
#5
#5