HI-PRESS TANGYE HYDRALITE PS620 Kullanım ve Güvenlik Talimatları Kılavuzu - Sayfa 3

Jacks HI-PRESS TANGYE HYDRALITE PS620 için çevrimiçi göz atın veya pdf Kullanım ve Güvenlik Talimatları Kılavuzu indirin. HI-PRESS TANGYE HYDRALITE PS620 10 sayfaları.

Sayfayı Yazdır

The ram should only be extended hydraulically; it should never be pulled out by hand or used to

carry the jack.

Do Not

position the jack by using the operating lever in the release valve. If the jack is t o be

placed some distance under the load, use the operating lever in the operating lever/quadrant

socket to position the jack.

Do Not

drop loads onto the jack. If the jack is inadvertently subjected to a shock load, remove

from service and have it checked by a competent examiner or service agent.

Do Not

overload the jack especially when lowering loads.

Do Not

under any circumstances go under a load when hydraulic jacks solely support it.

If using more than one jack, all the jacks must be able to individually raise the load e.g. two

PS620 jacks cannot be used to lift a 30T load as it impossible to pump both jacks at exactly the

same rate, or lower the jacks at exactly the same rate, one of the jacks will end up with an excess

load and is liable to fail. In such case two PS630 jacks should be used to raise a load of 30T.

Operating Environments

The jack is intended for use in industrial environments, inside or outside, between

temperatures of –20 to +50°C. Outside these limits, or in explosive atm ospheres/areas of

nuclear radiation, consult the manufacturer before use.

Noise and Vibration

By its design, the jack operates slowly under manual eﬀort. There is no noticeable noise or

vibration.