Aircotec Primus Kullanım Talimatları - Sayfa 5

Aviyonik Ekran Aircotec Primus için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. Aircotec Primus 5 sayfaları.

Sayfayı Yazdır
Press „SWITCH ON" and release.
The monitor display will show:
>> all segments, >> serial number
>> tension left battery
>> tension right battery
>> year >> date >> local time
Press "SWITCH OFF" and hold down.
Press „Basic Settings" and hold down.
Sequence:
>>vario acoustics 0, 1, 2, 3, 4 sec. Time-constant
>>vario digital 1, 2, 4, sec. Time-constant
>>climbing tone insert
>>sinking tone offset
>>signal free zone
>>sinking alarm
>>° Celsius or ° Fahrenheit
>>km/h, MPH or knots
>>QNH in hPa or (Inches x 100)
>> year >>month >>local time
Change settings with button 3, 4 and 5
(sequencely 1., 2., 3.)
Back to normal use, press and hold button 3
two seconds.
The temperature of the unit and the local time
(when the Stop-watch display is activated) are
shown for a period of 3 seconds.
ON
- Basic adj.
- OFF
- Time Temp.
1
2
ready
start
- stop
mark = marking while
the barogram is recording.
ready = Stop-watch is operational
(digits flashing).
start = start the stop-watch
- stop = stop the stop-watch
Change from „ALTI" (absolute or
difference altitude) to „QNH.
- QNH
- ALTI
3
mark
1 - set
- step
3 enter
Summary of operating instructions

Basic functions

Change from „meters" to „feet"
Or "feet" to "meters".
- m/FT
4
2.
adjust
Switch audible signal on/off, quiet/loud. To switch
from interval to continuous signal: press 3 times.
Proceed sequentially
for all changes of
figures (e.g.QNH or
altitude setting) i.e.:
1., 2., 3.,
green = stop watch function
blue = barograph function
yellow = settings function
•
Press and release
-
Press and hold down
Press simultaneously
Switch sinking
tone „on or off".
Select start place 1 or 5.
Zero-setting of differencial
altitude.
Set altitude to "zero"
(temporary altitude) and return
to "alti" with button 3.
- ALTI 1- 5
ALTI = 0
5
6
2.
adjust

WORKS SETTINGS

Changes in type of tone:
When button 6 is pressed,
the unit can be started with
button 1. The required type
of tone can set with button 6
and entered with button 3.
- Sink.
On / off