DAYCO D165DC Operatör El Kitabı - Sayfa 11

Kıvrım aleti DAYCO D165DC için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. DAYCO D165DC 19 sayfaları.

TROUBLESHOOTING

PROBLEM: CRIMPER WILL NOT RUN AT ALL

The white rocker switch is also a circuit breaker. Check to see that the circuit breaker has

not been tripped

Check the wall outlet. The crimper comes from the factory wired for a 110 volt single phase

circuit.

Use of extension cords or outlets with inadequate power can damage the motor . Do

not run the crimper from a portable power source.

Check the stop switch mounted to the switch bracket under the Micro-Crimp Adjuster. This

is a normally closed switch and if it does not close the crimper will not operate.

CAUTION: Do not operate the crimper with this switch jumpered as the pump will not shut off

and the brackets can be damaged.

Check the pneumatically actuated switch in the electrical box mounted on the motor. This

switch controls power to the motor and is actuated with air pressure from the bulb on the end of

the hose going into the box

PROBLEM: CRIMP DIAMETER TOO LARGE

Check crimper calibration and re-calibrate if required.

Incorrect die being used. Each die has a range of approximately 3mm (.120 in) above the

closed diameter of the die. The closed diameter is the die size stamped on the die ring.

Incorrect setting of the Micro-Crimp Adjuster. Check hose manufacturer's specifications.

Inadequate pump pressure. Check oil level in the pump. It should be 1-1/2 to 2 inches below

the fill plug. Replenish with ISO Viscosity Grade 46 hydraulic oil.

Inadequate lubrication of the dies and compression ring causing the pump to work harder

than normal to reach the required diameter.

Inadequate pressure being generated by the pump. This is most likely if the crimper can

crimp the smaller size hoses and not the larger hoses. When correctly adjusted, the pump should

generate approximately 10,000 psi.

Do Not adjust pump to produce in excess of 10,000 psi as damage to components or personal

injury may result

No pressure being generated by the pump. There should be a definite change in pitch of the

pump as it cycles into high pressure mode and begins to "work" harder.

PROBLEM: CRIMP DIAMETER TOO SMALL

Check crimp diameter and re-calibrate if necessary

Incorrect die being used (See die range under Crimp Diameter too Large)

Incorrect setting of the Micro-Crimp Adjuster. Check hose manufacturer's specifications.

PROBLEM: DIES STICKING IN COMPRESSION RING

Inadequate lubrication of the compression ring and die surfaces.

Page