GREAT PLAINS 1006NT Talimatlar Kılavuzu - Sayfa 6

Çiftlik Ekipmanları GREAT PLAINS 1006NT için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. GREAT PLAINS 1006NT 6 sayfaları. End wheel no-till

Sayfayı Yazdır
GREAT PLAINS 1006NT Talimatlar Kılavuzu
2.) SPRING TENSION ON THE OPENERS: The "W" clips on the opener spring rods
should be in the lowest hole. This is the correct location in all conditions. The "W"
clips can be raised one hole in the wheel tracks only if penetration is not adequate.
3.) SEED DEPTH: All opener "T" handles should be set the same (about
mid range) when starting. Check seed depth by digging down to the seed, adjust
to desired depth by moving the "T" handle. It may be desirable to put the T-
handles in the rows behind the wheel tracks, one hole deeper to maintain proper seed
depth.
1.) COIL TINE HARROW: A coil tine harrow is available as optional equipment that
will pull residue over the seed and help in reducing soil crusting. Adjust the harrow
for no-till by raising the front bar to run 1 inch to 1½ inches higher than the rear
bar. The front set of teeth should be set to run flatter than the rear bar.
OPTIONS