Gaggenau VG 231 RK Kurulum Talimatları Kılavuzu - Sayfa 5

Hob Gaggenau VG 231 RK için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Gaggenau VG 231 RK 8 sayfaları.

Changing the low burn nozzle:

Remove pan support and all burner parts.

Unscrew two fastening screws (Torx T20) and remove stovetop.

Remove control knob. Remove control panel: Unscrew the two

upper, lateral fastening screws (Torx T20). Raise control panel in

the rear and push it forward. Remove switch cover.

The low burn nozzle is located in the gas valve and is screwed in

from above. For easier accessibility, turn switch or remove

securing ring and remove switch. Unscrew the nozzle and insert

the new nozzle as specified in the low-setting nozzle table. The

nozzle must be screwed in fully.

Put switch, securing ring, switch cover and control panel back in

place and screw them tight. Put on control knob

Changing the full burn nozzle:

Remove securing clips on the burner pipes. Remove burner

pipes. Loosen screw on air-regulating tube. Remove nozzle

fitting

Remove nozzle and O-ring for inner circular burner by hand.

Unscrew nozzle for outer circular burner (SW10).

Check that O-ring is correctly positioned in new full-burn nozzle

for inner circular burner. Push nozzle onto burner pipe. Screw

new main nozzle for outer circular burner all the way into nozzle

fitting.

Put on nozzle fitting and burner pipes. Put on securing clips.

Set air-regulating tube to correct dimension after loosening the

screw (see nozzle table). Tighten screw again.

Put stovetop in place and screw it tight. Put burner parts and pan

support in place, positioning them correctly.

If it should be necessary to correct the low-setting nozzle as the

result of deviating gas types and pressure, the flow rate can be

increased by turning to the left.

These burners do not require the primary air to be adjusted.

Checking functions after the conversion:

The flames are adjusted correctly if no yellow tips are visible and if

they do not go out when switching over swiftly from the high to the

low setting.

Note: stick the adhesive label included with the nozzle set over the

rating plate of the appliance to document the changeover to a

different gas type.