Hi-Tech RO-300 DLX Kullanım ve Bakım Kılavuzu - Sayfa 3

Su Filtrasyon Sistemleri Hi-Tech RO-300 DLX için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Hi-Tech RO-300 DLX 10 sayfaları.

2.1

Plumbing

A certain amount of water must be used to continuously rinse the RO membranes and carry

the concentrated, rejected materials away from the membrane. The concentrate outlet is

located on the outlet side of the concentrate valve. Approximately 6 feet of 3/8 inch nylon

tubing should be connected to the concentrate outlet and run to an open drain. The tubing

must be unobstructed. There is no restriction as to the length of the tubing.

The RO permeate outlet is located on the end cap(s) of the membrane housings. The

permeate outlet is ½ inch tube. The permeate should be transported to the point of use

through high-quality nylon or stainless steel tubing. PVC pipe or other FDA-acceptable

materials.

Maximum recommended inlet temperature is 40 C.

2.3

Electrical

A ¼-HP, ½-HP or ¾-HP 220/50/1 is supplied, and is wired with an4-foot cord. A 3-prong

plug is provided for use in a standard household outlet receptacle.

An appropriate plug must be wired to the cord provided for use in a standard household

outlet receptacle for 220/50/1 units. All field wiring must comply with applicable national and

local codes.

WARNING :

2.4

Pump

The pumps used on this product line are rotary vane pumps. These pumps must be run on

filtered water only. When the pumps require servicing, simply remove the pump head with a

screwdriver and return it to Hi-Tech The head will be reconditioned and returned at a nominal

charge. It is advisable to purchase a new pump to use while the old pump is being evaluated

for reconditioning. At times, purchasing a new pump is less expensive than reconditioning

the old pump.

CAUTION :

TO REDUCE THE RISK OF ELECTRIC SHOCK, THE INCOMING

POWER SUPPLY MUST INCLUDE A PROTECTIVE EARTH

GROUND.

NEVER LET THE PUMP RUN DRY, AS THIS WILL CAUSE SERIOUS

DAMAGE TO THE MACHINE.