Hi-Tech ZycoTherm Kullanıcı Kılavuzu - Sayfa 6

Su Pompası Hi-Tech ZycoTherm için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Hi-Tech ZycoTherm 12 sayfaları.

Page 5

Running Screen

This is the Running Screen. From this screen you can start a run, navigate to the settings

menu, view faults, and see information about the current run.

START - This button will begin a run and start the timer. Once pressed will change to STOP,

and once the timer has ended the Red light above will turn green indicating pump is in motion.

COMM - This button indicates if there is communication between the pump and the controller.

If it says NO COMM then there is no communication between the pump and the controller.

SETTINGS - This button will take you to the settings menu.

FLOW RATE - Indicates the current flow rate of a run. It will constantly adjust depending on

the liquid moving through the pump.

TARGET FLOW RATE - This is the target flow rate derived from the material %, TPH, and

AC% - These parameters must all be inputted manually. When an Analog signal is present

either Plant TPH or AC TPH can be tracked depending on setup - see Tie-In Options for

details.PUMP SPEED - This is the output % that the controller is sending to the pump. This

will constantly adjust depending on the current flow rate and need.