Daylab Daylab 35 Kullanıcı Kılavuzu - Sayfa 4

Yazıcı Daylab Daylab 35 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Daylab Daylab 35 17 sayfaları. Slide printer for polaroid

Sayfayı Yazdır

Loading film

Remove the base of the Daylab 35 by lifting

the exposure unit up. Invert the film holder.

Unlatch and open the film-holder door

(2): Pull down both ends of the latch and

open the film-holder door (2m).

Before loading film into the film

holder, check that the steel rollers are

clean. Dirt on the rollers may cause a

number of picture problems such as

repeated spots and bars on the pictures,

poor colors, or jammed film, as explained

Possible problems, causes

Hold the film pack by the edges only.

Insert the closed end of the pack at an

angle (3), then push the pack down into

position.

Check that the white leader and

processing tabs are free, as shown (4),

not caught between the pack and the film

chamber.

Recommended Polaroid instant films,

for use with the following Daylab 35 applications:

Color applications:

Black and white applications:

*Use Type 665 positive/negative film to produce a reusable negative of your image to create

multiple black-and-white prints.

**Note that the development time of Type 664 film at 75°F (24°C) and above is only 30 sec.

Close and latch the film-holder door:

Hold the door closed and push the latch

up overthe end of the film holder (5) so

that it snaps into position.,

Caution: Before continuing with the next

steps, check the dark slide/viewing panel

to be sure that it is inserted all the way

into the film holder. If it is not, you risk

exposing the film.

The black safety-cover tab (5n) must

extend from the film holder. If not, reopen

the door, and straighten the safety-cover

tab.

Grip the tab firmly, and pull the safety

cover straight all the way out of the film

holder (6).

When you remove the safety cover, a

white leader tab (6o) should protrude

from the slot. If it does not, carefully open

the door (doing so in dim light) and free

the tab. Close and latch the door, with the

tab extending outside.

The film holder is now loaded and

ready for the first exposure.

Slide

Emulsion/Image

copies

transfer

669

679

689

664**

Inter-

negative

665