Hi-Velocity RBM-50 Kurulum Kılavuzu - Sayfa 5

Kontrol Ünitesi Hi-Velocity RBM-50 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Hi-Velocity RBM-50 12 sayfaları. Rbm refrigerant base module

Sayfayı Yazdır

1. Change Configuration

Once the RBM coil configuration and placement of the return air ducting has been decided, the return air knockout(s) can be cut.

The pre-measured guide cuts supplied with the RBM coil should always be used to make the first cut. For this first cut, do not use a saw

blade longer than 5" (125mm) or damage to the coil can occur.

TO AVOID DAMAGE: After the first initial cut using the return air knockout(s) a

metal shear must be used to make the return air cutout opening match more closely

to the filter or return air ducting size to maximize flow capacity. Use this cut method

for both coil inlet and outlet.

Step 1: First cuts (using

pre-measured guide cuts)

can be made with a power

tool (no longer than a 5"

blade)

Fig. 12

www.hi-velocity.com

Return Air Cutouts

Step 2: Second cuts (to match

more closely to filter or R/A ducting

size) must be made with a metal

shear to avoid damage to the coil

Mounting the cooling coil to the fan coil can be done with the T brackets supplied

(Fig. 12), ensure that no screws puncture the drain pan or coil. Use the provided double

sided tape to air seal the RBM to the fan coil.See specifications page for the dimensions

of the fan coil units and cooling modules.

-5-

RBM Refrigerant Base Module Installation

Pre-Measured

Guide Cuts

Mounting Brackets

Module RBM