Dynabrade 64100 Kullanım Kılavuzu - Sayfa 6

Endüstriyel Ekipmanlar Dynabrade 64100 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Dynabrade 64100 8 sayfaları. 21" metalworking station

Sayfayı Yazdır

Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade

OPERATION INSTRUCTIONS

1. Before operation starts, you must first make sure that the main tank

is at its proper water level in the "Power off" position. If water level is

low add water to the main tank or, operate your reservoir valve to the

fill position until desired level is reached as indicated on the label at

the front of the machine. Continue by then switching reservoir valve

to the "float" position.

2. Turn power switch on to start filtering action and begin work.

3. Check reservoir level every 8 hours and refill as necessary.

UPPER ACCESS PANEL

(Removal may be required to plug in accessory)

(3)

(4) ADJUSTING THE

FLOAT ARM MAY

BE REQUIRED TO

FINE TUNE WATER

TRANSFER FROM

RESERVOIR TO

MAIN TANK

LEVEL HIGH BEND DOWNWARD

LEVEL LOW BEND UPWARD

Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade

W E T D E B U R R I N G S TAT I O N : O P E R AT I O N

4. During operation, the float valve will transfer (Drip) water into the

main tank from the reservoir to make up for evaporation. Turn power

off after extended operation (Min 4 Hours) and re-check initial "Power

off" water level. If low, carefully bend the brass rod on the float

assembly to move float body up approximately 1/16". If "Power off"

water level is high, bend the brass rod on the float assembly to move

the float body down approximately 1/16". Re-check again after

extended operation.

(See set-up instructions for proper water level)

(2) POWER SWITCH

AUXILIARY

OUTLET 115V

ACCESSORY

CORD WRAP

(1) WATER LEVEL WINDOW