Hi-Z Antennas HIZ-SS2 Manuel - Sayfa 9

Alıcı Hi-Z Antennas HIZ-SS2 için çevrimiçi göz atın veya pdf Manuel indirin. Hi-Z Antennas HIZ-SS2 12 sayfaları. Receiving array controller with an oled display

Sayfayı Yazdır

Hi-Z Receiving Array Shack Switch Using an OLED Display

The

"Display

values of brightness available with the factory default value being BI=2. To access the

"Display Brightness" function depress the Hi-Z knob and rotate the knob until you see

"Display Brightness". Depress the knob again and the screen will change to where you

can see "BI" and a "BV" values. Rotate the knob to change between the 5 BI values

available. This is no place for "All Knobs To The Right". The factory default is BI=2 and

in normal room light the display is quite readable. Again, these OLED displays are new

and the lifetime is unknown so be gentle with your selection of BI value. Depress the

knob and you will return to the normal Direction display screen.

4.8.

Rly Test, Walking 1s

The

"Rly Test Walking

user to verify switched outputs quickly. This function allows all 6 of the switched outputs

to be switched to ground in a sequential manner. The outputs will switch for a 1 second

period then advance to the next higher output connector number. It will continue to

switch through this sequence until stopped. To enable this function depress the Hi-Z

knob and then rotate it until the "Rly Test Walking 1s" function is displayed. Depressing

the knob again will start the function. Depressing it again will terminate the test.

4.9.

Rly Test, Val

This function is a quick way to activate any one of the 6 switches at the

output connector. As you rotate the Hi-Z knob when this function is enabled the unit will

switch any of the available outputs to an on state for testing purposes. To select this

function, depress the Hi-Z knob and rotate it until the

Depress the knob again and then when you rotate the knob you can select any

individual output switch to an on state. Depressing the knob again disables this function

and returns you to the direction readout screen. This is a way to test or activate the

unused outputs depending on the array you have chosen.

4.10.

Display Volts

Brightness" function does exactly what it says. There are 5

1's" function is a diagnostic test mode that allows a

Hi-Z Antennas Shack Switch 2 Rev.1 10-13-2019

"Rly Test,

Val" function shows.