GREAT PLAINS Terra Max HT1100-20 Saha Ayarlama Kılavuzu - Sayfa 5
Tohumcular GREAT PLAINS Terra Max HT1100-20 için çevrimiçi göz atın veya pdf Saha Ayarlama Kılavuzu indirin. GREAT PLAINS Terra Max HT1100-20 6 sayfaları. Tillage
Ayrıca GREAT PLAINS Terra Max HT1100-20 için: Montaj Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Hydraulic Single Point Depth Stop Adjustment:
The hydraulic dept stop will ensure a consistent depth
every time the implement is lowered.
1) Once the machine is level and set to the desired
working depth, set the hydraulic depth stop at the
front of the machine.
2) After setting the stop, if a change of depth is
desired, one full turn of the handle either in or out will
the change the depth approximately 1/4" up or down
respectively.
Note: Standard operating depth is 1-4". For first time
settings a depth of 2.5-3" is recommended unless it is
too wet to go this deep.
Slight tire to ground pressure should be maintained to
prevent cylinder pin and clevis wear. If after setting
the depth stop, the detent on the tractor kick out
before the stop contacts the button on the depth stop,
slow the hydraulic flow speed down.
Finishing Reel (Single or Double)
Note: Finishing reel must either be ran in "FLOAT" or
active hydraulics during field operation. Never run in
Neutral.
1) Initially it is recommended to start these out in the
"FLOAT" position so that we are not applying pressure
which could affect other components of the machine.
Once all previous settings have been completed,
increase down pressure to the reels.
2) Initial down pressure should be about 200-300 PSI.
Never exceed 800 PSI. Note: Do not run down pres-
sure in very wet fields.
49661
49662
49661
5 of 6
Document
#TLUS625C-0001B