DYNACO ST-70 Kurulum ve Kullanım Kılavuzu - Sayfa 6
Amplifikatör DYNACO ST-70 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. DYNACO ST-70 9 sayfaları. Driver 6gh8 ecf82 for the ab-q-st70 auto bias module
Ayrıca DYNACO ST-70 için: Montaj Kılavuzu (14 sayfalar)
Sayfayı Yazdır
1. 1MOhm potentiometers must be connected to inputs 7 and 17 of the PC-3 driver. If these
potentiometers are not present on the amp, 1MOhm resistors (R2 and R15) must be connected
to ground at inputs 7 and 17. If this does not happen, the PC-3 driver will fail and the signal will
have significant distortion!
2. The AB-Q ST-70 module is already preset to a cathode current tubes EL34 of 38 mA. There is no
need to set it again.
If you want to set a different cathode current on the EL34, follow these steps: