DYNACO Stereo 410 Kurulum Kılavuzu - Sayfa 6

Amplifikatör DYNACO Stereo 410 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DYNACO Stereo 410 12 sayfaları. Replacement rca jack

Note the position of the ground lugs and the orientation of the contacts of the jacks as

shown in Figure 4. The ground lugs should ideally be at 12 o'clock, but anywhere from

11 o'clock to 1 o'clock is fine.

You'll want to make sure that the nuts that hold the jacks in place are snug. Here's the

process I use:

1. Assemble everything as shown, but just finger tight for now.

2. Position the lugs (back view) at 10 or 11 o'clock.

3. Use a pair of slip-joint pliers on the base (widest part) of the front side of the

RCA jack and an 11/32" nut-driver on the nut. Turn the nut to make a snug

mechanical connection. The lug will move clockwise a bit, stopping in the range

from 11 to 1 o'clock.

4. You may have to try the process a few times to get the feel of where to start the

tightening operation.

Make sure that the nuts and jacks are quite tight. You don't want them to come loose

once they are installed.

Section 4: Removing the Old RCA Jack Assembly

Make sure that your amp is unplugged before beginning. Wait at least one minute to

allow the large capacitors to fully discharge.

The object of this procedure is to separate the big black heatsink assembly from the body

of the amp. This will give you access to the old RCA jack assembly.

Page 6 of 12