7LS MD7-1000 Kullanım Kılavuzu ve Garanti Bilgileri - Sayfa 6

Kişisel Bakım Ürünleri 7LS MD7-1000 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Garanti Bilgileri indirin. 7LS MD7-1000 20 sayfaları. Microdermabrasion+ cooling surface

Sayfayı Yazdır

T R O U B L E S H O O T I N G

PROBLEM

POSSIBLE CAUSE

• Unit is not charged

Unit will not operate

• Unit needs to cool down as

indicated by a flashing blue

LED

Cooling surface will not

• Cooling button not pressed

operate

• Unit is not fully charged

Unit seems to be losing

suction

• Black wool filter needs to

be replaced

• Diamond tip is not securely

installed

Diamond tip no longer

• The diamond tip has an

seems rough

accumulation of skin cells

F A Q

H O W O F T E N S H O U L D I U S E T H E P R O D U C T ?

It's best to start slowly – usually just once a week. Then build up to 2 or 3 times a week

if comfortable for your skin.

W I L L I T H U R T ?

No. Treatment should not be painful. Depending on the sensitivity of your skin, you may

feel slight discomfort from the diamond tip as it moves across the skin. There could

be some short-term redness or sensitivity after treatment, but this will soon subside. If

treatment is uncomfortable, you may need to use a lower power setting or switch to

the sensitive diamond tip. The cooling surface will help soothe the skin post-treatment.

SOLUTION

• Charge the unit, placing firmly into

the charging base

• Press and hold the power button

for 1 second to turn the power on

• Check circuits, fuses. Try a different

outlet

• Let product sit for an hour prior to

reuse

• Press the cooling button for

1 second. A blue LED will glow

indicating the cooling surface is on

• Charge the unit, placing it firmly

into the charging base

• Replace the filter

• Make sure the diamond tip is

secured tightly to the unit

• Clean the debris from the diamond

tip using the included brush

• Deep clean the diamond tips in an

ultrasonic cleaner (i.e., a jewelry

cleaner) to remove excess skin cell

buildup

C A N I U S E T H E P R O D U C T I N C O M B I N A T I O N W I T H

A N T I - A G I N G C R E A M S / S E R U M S ?

If your anti-aging cream or serum contains AHA (or acid), then it should not be used on

the same day as the microdermabrasion treatment, but can be used on non-treatment

days. Non-AHA (acid free) anti-aging products can be used at any time.

F C C S T A T E M E N T

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause

undesired operation.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modifications to this equipment. Such modifications could void the user

authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules and CAN ICES-3 (B)/NMB-3 (B).

These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.