HiB 52900 Montaj Talimatları - Sayfa 2

İç Mekan Mobilyaları HiB 52900 için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. HiB 52900 4 sayfaları.

Installation

WARNING

It is important to follow manufacturer's installation guidelines to ensure the cabinet is

fixed securely to the wall.

Please use the supplied wall fixing bracket and follow the correct installation method. If

the instructions are not followed appropriately there is an increased safety risk to the user.

NB. Cabinets must be installed with a minimum distance of 150mm between the infra-red sensor

switch and any adjacent wall or object to ensure correct operation of the sensor

1. Position the cabinet in a suitable location (according to the zonal diagram on the back page

(Fig. D) ensuring that the mains supply cable is within reach of the cable connection point of

the cabinet.

2. Carefully mark the desired position of the top of the cabinet on the wall using a soft pencil.

3. Remove the cabinet from the wall and using a spirit level, mark a horizontal line 40mm below

the pencil mark. Hold the mounting bracket in place with the holes corresponding with the

marked line. Ensure the bracket is central, and mark the position of the holes (Fig. A).

4. Before drilling, ensure there are no hidden cables or pipes behind the mounting points.

Drill the required holes in the marked positions. If drilling through tile, use a ceramic drill bit.

Insert the wall plugs level with the surface of the wall. If fitting to a tiled surface, wall plugs

should be inserted below the tile surface to avoid cracking. NB. For plasterboard walls,

specialist fixings should be purchased, available from any DIY or hardware store. Fix the

bracket to the wall using the screws provided.

5. Temporarily hang the cabinet on the top bracket (Fig.B), and mark the position of the bottom

mounting hole on the wall using a soft pencil, then remove the cabinet from the wall.(Fig. C)

6. Drill a hole in the wall where you have marked with the soft pencil. Insert a wall plug level with

the surface of the wall as per step 4.

7. Ensure the domestic electrical mains supply to which the product is being connected is

turned off. Connect the domestic mains supply according to Fig.E - OVERLEAF.

8. When the product is wired correctly, hang the cabinet on the top bracket (Fig.B) and

secure the cabinet with a screw through the bottom mounting hole (Fig.C). Take care not

to overtighten the screw against the mirror glass, the screw is not load bearing - It is only

intended to prevent the cabinet from moving away from the wall.

9. When the cabinet is correctly fitted, adjust the shelf support brackets to your desired height

ensuring the matching brackets are level. This is done by slightly loosening the screw, do not

remove the screw completely. Once in position tighten screw to secure the bracket and put

the glass shelf into the shelf support bracket.