Aircraft In Miniature HW72-03-001 Tarihçe, Notlar ve Montaj Talimatları - Sayfa 4
Oyuncak Aircraft In Miniature HW72-03-001 için çevrimiçi göz atın veya pdf Tarihçe, Notlar ve Montaj Talimatları indirin. Aircraft In Miniature HW72-03-001 9 sayfaları. 1:72 metal kit of the 1909 santos dumont demoiselle
Sayfayı YazdırC Form each spoke disc.
(1)
Put each disc into the cavity in the female form tool.
(2)
Put the male form tool into the cavity and press the disc into a cone. Figure 2
shows a vice being used to compress the form tool.
NOTE: These photographs show typical wheels,
spoke discs and tyres. They are NOT
specific to this kit.
(3) Remove the form tool from the vice and remove the formed disc of spokes.
(4) Do steps 1 C (1) thru 1 C (3) again for each of the spoke discs.
2 ASSEMBLE THE FUSELAGE PRIMARY STRUCTURE
A Remove the fuselage upper and lower sections from the fret and remove any burrs from
the attachment tabs.
B Fold the fuselage upper section into a 'V' shape, with a width equal to the fuselage lower
section. Note - there are fold lines etched on the inner face of the fuselage upper section.
C Attach the fuselage upper section to the fuselage lower section.
3 WING ASSEMBLY
A Remove the left and right wings and the front and rear spars from the fret and remove any
burrs from the attachment tags.
B Twist all the ribs on each wing through 90°.
C Engage the slots in the front and rear spars in the slots in the ribs of the right wing then bond
the wing spars in place.
D Put the rear spar through the fuselage structure. Engage the slots in the front and rear spars
in the slots in the ribs of the left wing then bond the wing spars to the ribs of the left wing.
Figure 2
(see Figure 4)
(see Figure 3)
Figure 3