HiB Novum NF02SBU50 Series Montaj Talimatları Kılavuzu - Sayfa 5

İç Mekan Mobilyaları HiB Novum NF02SBU50 Series için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. HiB Novum NF02SBU50 Series 16 sayfaları.

Sayfayı Yazdır

Floor Standing Installation

Ensure all components are present before beginning installation.

2. Remove back panels and non-fixed shelves.

3. To install the legs, turn the carcass upside down on a soft surface.

4. Fix the leg brackets to the base of the unit(s) using the pilot holes provided.

See Fig. 1.

5. Ensure the tab is in the correct position overlapping the carcass side panel.

See Fig. 1.

6. For a BTW unit, fix the leg bracket into the pre-drilled holes using the screws

provided. See Fig. 2.

7. Insert the legs into the leg brackets.

8. Adjust the legs to the required height by turning the feet. The HiB standard

plinth height is 15cm, see Fig. 3.

9. Position the units together in the configuration required against the wall.

Using a suitably sized spirit level, adjust the feet to level the units.

10. Clamp the units together. Using the screws and pre-drilled holes provided,

secure the units together, see Fig. 4.

11. Check the level of the units using a suitable spirit level and adjust the feet

where necessary.

12. Secure the units to the wall using the pre-installed hangers.

13. Check units are square against the wall and adjust where necessary.

14. Replace all back panels and shelves.

Screws and pre-drilled holes in the carcass have been supplied to secure the

To fit the countertop, please refer to the fitting instructions supplied

end panels to the carcass.

with the countertop.

hib.co.uk