GREAT PLANES COMBAT MUSTANG Combat P-51 ARF Kullanım Kılavuzu - Sayfa 10

Oyuncak GREAT PLANES COMBAT MUSTANG Combat P-51 ARF için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES COMBAT MUSTANG Combat P-51 ARF 20 sayfaları.

Sayfayı Yazdır

GREAT PLANES COMBAT MUSTANG Combat P-51 ARF Kullanım Kılavuzu

glue the horizontal stab to the fuselage by wicking thin CA

into the joint. Do this on both the top and bottom of the

horizontal stab.

5. Insert a hinge into each of the elevator and horizontal

stab hinge slots, checking to be sure the hinge fits easily

into the slot. If any of the hinge slots is too tight for the hinge,

clean out the hinge slot with a #11 blade. Drill a 5/64" [2mm]

hole in the leading edge of each elevator for the elevator

joiner wire.

6. Insert the hinges into the slots in the horizontal stab. If

the hinges do not remain centered, stick a pin through the

middle of the hinge to hold it in position. Insert each half of the

elevator onto the hinges and the elevator joiner wire in the

horizontal stab. Remove the pins and then apply six drops of

thin CA to each of the hinges.

7. Insert the vertical fin into the slot in the fuselage. Trace

the outline of the fuselage onto the fin. Cut the covering from

the fin the same as was done with the horizontal stab.

8. Check to be sure the vertical fin is perpendicular to the

horizontal stab. When satisfied with the positioning of the

vertical fin, wick thin CA into the slot.

9. Once the thin CA glue has cured, position the front of

the fin so that it is centered on the fuselage. Wick a small

amount of thin CA between the fin and the fuselage. There

is no need to remove any covering from the fuselage when

applying the glue.

Install the Elevator Pushrods & Servo

1. Cut the covering from the left side of the fuselage for

the elevator pushrod opening.

2. Install a nylon clevis onto the Z-bend of the 1 x 508mm

pushrod wire.