GREAT PLANES Cosmic Wind Kullanım Kılavuzu - Sayfa 12

Oyuncak GREAT PLANES Cosmic Wind için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES Cosmic Wind 20 sayfaları.

Install the Rudder Servo

❏

1. Install the rudder servo following the same procedure

used to install the elevator servo. Note: Use the small nylon

control horn on the rudder.

❏

1. Place the aileron servo tray over the aileron servo

opening in the top of the wing. Use a ﬁ ne tip marker to mark

the outline of the aileron tray on the top of the wing. Remove

the tray and use a sharp hobby knife to remove the covering

from inside the marks. Be careful not to cut the balsa sheeting.

❏

2. Glue the aileron servo tray over the aileron servo opening.

❏

3. Remove the rubber aileron torque rod thread protectors.

Thread an aileron torque rod horn on to both aileron torque

rods so that the threads are ﬂ ush with the top of the torque

rod horns. Adjust the horns so that both of them are the same

distance from the wing.

❏

4. Attach the aileron servo to the servo tray either with glue

or 2 × 6 mm self tapping screws.

❏

5. Insert the Z-bend of the 1× 70 mm aileron pushrod

wires in the two aileron torque rod horns.