GREAT PLANES Douglas DC-3 Kullanım Kılavuzu - Sayfa 12

Oyuncak GREAT PLANES Douglas DC-3 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES Douglas DC-3 20 sayfaları.

Install the Servos

1. Using 220-grit sandpaper, sand or rough-up the outer

portion of the two pushrod outer plastic tubes. Locate the

nylon tie strap supplied in the parts bag and tie it

approximately 1/2 the length of the two pushrod outer tubes.

Insert the steel pushrods from the rear of the fuselage and

run them inside the two outer tubes. Note that these tubes

should be X'd at the nylon tie strap.

2. Work the outer tubes back and through the exit slots in

the rear of the fuselage.

3. Place the forward end of the tubes into the holes in the

servo tray as shown in the photo and glue them into place. Also

glue the outer tubes at the exit points at the rear of the fuselage.

4. Assemble the elevator and rudder servos as shown in

the above photo using the grommets, brass eyelets and

screws supplied with the servos. Install a screw lock

connector on each servo arm with a thumb nut with a drop

of thread lock. Note that the servo arms have been modified

so that only one arm remains.

5. Mount the two servos into the servo tray in the manner

shown in the above photo. Temporarily place the push rods

into the screw lock connectors and tighten the set screws on

the top of the connectors.

1. Using a sharp hobby knife, cut the covering away from

both rudder hinge slots. Test fit the hinge points into the