GREAT PLANES ElectriFly PBY Catalina Kullanım Kılavuzu - Sayfa 11
Oyuncak GREAT PLANES ElectriFly PBY Catalina için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES ElectriFly PBY Catalina 20 sayfaları. Arf
Sayfayı Yazdır
Install the Elevator and Rudder
Servos and Pushrods
❏
1. For both the rudder and elevator servo install a servo
extension onto the servo lead. With the Futaba 3103 servo a
6" [152mm] extension is adequate. Other brands may require
a longer or shorter extension. To reach the receiver you need
9" [230mm] of wire from the servo to the receiver. Secure the
servo lead to the extension with tape, a piece of shrink tube or
some other method to keep them from coming unplugged.
❏
2. Remove three of the four arms from the servo horn,
leaving the longest arm in place. Enlarge the last hole in
the servo arm with a #57 drill. Install an aluminum screw
lock connector into the hole and lock it in place with a nylon
retainer. Install a set screw into the screw lock connector.
Install the servo into the opening on the right side of the
fuselage using the hardware that came with the servo. Center
the servo and install the servo arm as shown.
RETAINER
❏
into the left side of the fuselage, sliding it into the servo
compartment. Slide the wire into the hole in the screw lock
connector and lightly tighten the set screw against the wire.
❏
a control horn. Slide the screw lock connector onto the
pushrod wire. Position the control horn as shown, mark the
11
3 Install one of the .95 x 360mm [14"] long pushrod wires
4. Install a screw lock connector into the outer hole of