Aircraft in Miniature Limited Historic Wings Wright Flyer 1 1903 Montaj Talimatları Kılavuzu - Sayfa 8
Oyuncak Aircraft in Miniature Limited Historic Wings Wright Flyer 1 1903 için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Aircraft in Miniature Limited Historic Wings Wright Flyer 1 1903 8 sayfaları. 1:72 metal kit
9
Attach the detail parts (Refer to Figure 8)
A Drill 0.018 inch (0.45 mm) diameter holes in the hub of each propeller, and in the braces (P3 and P5)
and chain drives (P2 and P4) - (where they fit on to the propeller supports).
B
Attach the radiator and instrument cluster to the centre, forward interplane strut.
C
Attach the fuel tank to the left, inboard, forward interplane strut.
D Install the engine, chain drives, and propellers.
(1) Put the feet on the bottom of the engine in the slots of each engine support rib, and attach the engine
to the lower wing.
(2) Use the holes drilled in step 9 A, and put the braces (P3 and P5) and chain drives (P2 and P4) on to
the propeller supports. At the same time, attach them to the flywheel on the back face of the engine.
(3) Attach the generator to the outboard engine support rib, with the generator touching the gear wheel
of the chain drives.
(4) Use the holes drilled in step 9 A, and attach the propellers.
E
Attach the elevator control (C1) between the fuselage frames.
F
Attach the two fuselage braces (F3) to the fuselage frames, and to the inboard interplane struts.
Chain
drive -
short - P2
Brace,
short - P3
Radiator
Engine
Generator
Right
Elevator
Control - C1
Forward
Figure 8
10 Paint the details as shown on the drawing in the centre page of these instructions.
11 Paint the two figures supplied. We have no specific information, but all photographs seem to show the two
brothers wearing dark jackets or waistcoats, with white or light coloured shirts. Faces and hands should be
pink or 'flesh'.
12 Lay the prone figure on the lower wing, and stand the second figure where required.
The manufacturers reserve the right to alter parts; add to, or delete parts without prior notification
19, Watling Street, Nuneaton, Warwickshire, CV11 6JJ, England
Instrument
Cluster
© Aircraft In Miniature Ltd 2003 - Initial Issue - 17th December 2003
in the interests of quality control, production, or product improvement.
This kit is manufactured in the United Kingdom by
Aircraft In Miniature Limited
Email: info@aim72.co.uk - Web site: www.aim72.co.uk
Propeller (1 x left,
Brace, long
- P5
Chain drive -
long - P4
1 x right)
Fuel tank
Fuselage
Brace - F3
(x2)