GREAT PLANES Fling DL ARF Kullanım Kılavuzu - Sayfa 6

Oyuncak GREAT PLANES Fling DL ARF için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES Fling DL ARF 16 sayfaları.

ASSEMBLE THE WING

❏ ❏

1. Cut a 3/16" x 1/2" [4.8 x 13mm] slot in the bottom

of the wing centered with the aft end of the hole in the root

rib and 3/16" [4.8mm] from the wing center.

❏ ❏

2. Slide the aileron servo lead through the wing and

out the hole you just made.

❏ ❏

3. Plug the servos and battery into your receiver. Turn

on the transmitter to center the servos.

❏ ❏

4. Make a one-sided servo arm and position it on the

servo as shown in the picture. Make sure that the arm is

centered with the radio on and the trim centered.

❏ ❏

5. Clean the side of the servo with alcohol. Lightly coat the

inside of the servo opening with medium CA. Press the servo into

the center of the servo opening. Use the pushrod and servo

cover to position the servo.

NOTE: If the CA is not spread thin enough it might wick into the

servo and cause the gears to bind. Do Not Use Thin CA!

❏ ❏

6. From the 1/16" x 6" [1.6mm x 150mm] pushrod

make a pushrod with Z bends on each end that goes from

the servo arm to the center of the hinge line.

❏ ❏

7. Cut the covering from the control horn slot on the

bottom of the aileron. Fit the plywood control horn to the

pushrod. Fit the control horn in the slot. Make sure that the

arm is centered with the radio on and the trim centered.

Align the aileron TE and wing TE, then glue the control horn

to the aileron with thin CA.

❏ ❏

8. Trim the plastic aileron servo cover and place over

the servo. Check that the cover does not interfere with the

movement of the servo. Tape the cover to the wing.