GREAT PLANES FW-190 Focke Wulf Kullanım Kılavuzu - Sayfa 10

Oyuncak GREAT PLANES FW-190 Focke Wulf için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES FW-190 Focke Wulf 20 sayfaları.

❏

5. Epoxy the other tail servo into the cutout from the right

side of the plane side with the output shaft toward the front.

Center the servo with your radio and screw the extended arm

onto the output shaft with the arm oriented straight down.

❏

6. Center your aileron servo with your radio and screw the

extended double-sided arm onto the servo. When you glue the

extended servo arm, be sure it is exactly centered as shown.

Epoxy the aileron servo into the cutout in the fuselage.

Install the Control Horns & Pushrods

❏ ❏

1. Locate the two 2-3/4" [70 mm] prebent aileron

pushrods. Slightly enlarge the outer hole on the aileron

servo arm. Insert the Z-bend end of the pushrods into the

outer hole in the aileron servo arm.

❏ ❏

2. Center your aileron servo to ensure it is at neutral. Use

a small clamp or some masking tape to hold the aileron at

neutral. Align the pushrods straight back towards the ailerons.

❏ ❏

3. Locate a black nylon control horn. Trim the small

plastic section away as shown.

❏ ❏

4. Make a small 1/4" [6.4 mm] long cut in the aileron

behind the bearing. Insert the 90° bend of the pushrod into

the middle hole of one of the black nylon control horns.

❏ ❏

5. Apply a small spot of foam-safe CA to the bottom of

the control horn and insert it into the cut in the aileron. Press a

nylon backplate on the backside of the control horn as shown.