GREAT PLANES helicat Kullanım Kılavuzu - Sayfa 6

Oyuncak GREAT PLANES helicat için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES helicat 16 sayfaları. Electrifly series

ASSEMBLE THE AIRPLANE

❏

1. Connect the aileron servo to the receiver. Use your

ESC or a receiver pack to power the receiver. Turn on your

transmitter and center the aileron servo. Do not skip this

step, as the aileron servo must be installed into the fuselage

with the servo horn attached to it.

❏

2. Cut two arms from a four-arm servo horn as shown.

Enlarge the outer holes in the remaining servo arms with a

3/64" [1.2mm] drill bit.

❏

3. Install the servo horn perpendicular to the servo case.

❏

4. Cut a slot in the fuse on the right side large enough to

accommodate the servo connector in the location shown in

the picture. The exact placement will depend on the servo

manufacturer and where the servo lead wire exits out of the

aileron servo being used.

❏

5. Feed the aileron servo lead through the slot you cut

into the fuse.

❏

6. Fit the aileron servo into the aileron servo bay with the

servo spline towards the aft end of the plane.

❏

7. With the servo centered in the aileron servo bay, apply

a couple of drops of thick foam safe CA glue to each servo

case tab, securing the servo to the fuse. Add a couple of

drops of CA glue near the base of the servo case as well.

It does not require much CA glue to secure the servo to the

fuse. Excess glue will simply make it difficult to remove the

servo in the future.