GREAT PLANES L-39 Kullanım Kılavuzu - Sayfa 7

Oyuncak GREAT PLANES L-39 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES L-39 16 sayfaları. Electrifly series

❏

4. Connect a pushrod wire with Z-bend to each of the

aileron servo arms.

❏

5. Use the included thumb screw pushrod connectors to

connect the aileron pushrods to the outer holes in the control

horns as shown. Center the ailerons in the neutral position

and tighten the thumb screws against the pushrods.

❏

6. Glue the aileron pushrod covers over the servo arms.

Be sure that the covers are positioned so that they will not

interfere with the pushrods when the ailerons are deﬂ ected

up and down.

❏

7. Attach the wing tip tanks to the wing as shown. The

magnets will hold them in place during ﬂ ight.

❏

8. Connect the included motor lead extensions to the

three wires on the motor. Secure the extensions using tape

(not included).

❏

9. Test ﬁ t the ducted fan unit into the fuselage channel

by feeding the motor lead extensions through the hole in the

bottom of the channel and aligning the unit with the molded

grooves in the channel. Conﬁ rm that the rotor cone does not

contact any part of the fuselage. If necessary, use a hobby

knife to carefully trim the contacting area away from the fuse.

When satisﬁ ed, use 30-minute epoxy to glue the ducted fan

unit into the duct channel. Clean up any excess epoxy with

a dry paper towel.