GREAT PLANES Riot 3D Kullanım Kılavuzu - Sayfa 11

Oyuncak GREAT PLANES Riot 3D için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES Riot 3D 20 sayfaları.

❏

17. Insert a Z-bend clevis (A1) into four closed ended

hinge points (C4) as shown.

❏

18. Cut a slot in the aileron and insert the closed ended

hinge points (C4) with the Z-bend clevis (A1) facing the

fuselage as shown. Glue in place with CA.

❏

19. Insert a 6" [153mm] carbon pushrod between the

Z-bend clevises (A1). Align both ailerons at neutral and glue

the carbon pushrod in place. Trim the carbon rod as needed.

Be careful as you get only one chance for proper

alignment before the glue sets.

Motor & ESC Installation

❏

1. The power system recommended for the Riot 3D ARF is

the ElectriFly RimFire

™

APC Slo-Flyer prop, and Silver Series SS-8 Amp ESC. This is

the power system that will be illustrated in the manual. If you

choose another power system for your Riot 3D ARF, use the

manual as a general guide for your installation.

❏

2. Attach the motor to the firewall as shown using three

#2 x 1/8" [3.2mm] screws and #2 washers. Remove the

screws and harden the mounting holes by applying thin CA.

Reinstall the #2 x 1/8" [3.2mm] screws and #2 washers. Drill

a 3/8" [9.5mm] hole in the lower right corner of the firewall

as shown for routing the motor leads.

28-22-1380kV out-runner motor, 8x3.8