GREAT PLANES Riot 3D Kullanım Kılavuzu - Sayfa 7

Oyuncak GREAT PLANES Riot 3D için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES Riot 3D 20 sayfaları.

❏

8. Carefully cut a slot for the rudder control horn in the

area marked on the sketch.

❏

9. Using three CA hinges, attach the rudder to the fin and

fuselage. Use three (3) drops of thin CA on each side of the

hinges. Wipe up any excess glue. DO NOT use accelerator

on the CA. This will cause the hinges to be very stiff and

possibly break.

❏

10. Glue the tail skid in place along the centerline of the

fuselage as shown.

❏

11. It is easiest to attach the canopy at this time. Later,

the wings may make canopy installation a little more difficult.

Attach the canopy using clear strips of tape or use canopy

glue. Do not use CA as this will distort the plastic or cause it

to "fog" over.

Mount the Wings

❏

1. Attach each of the ailerons to the wings using three

CA hinges.

❏

2. On the bottom wing ailerons ONLY, carefully cut a slot

in the aileron for the control horn in the location shown in

the sketch.

HOW TO CUT COVERING FROM BALSA

Use a soldering iron to cut the covering from the fin. The

tip of the soldering iron doesn't have to be sharp, but a

fine-tip does work best. Allow the iron to heat fully.

Use a straightedge to guide the soldering iron at a rate

that will just melt the covering and not burn into the wood.

The hotter the soldering iron, the faster it must travel to

melt a fine cut. Peel off the covering.