GREAT PLANES Sport Float Kit ARF Kullanım Kılavuzu - Sayfa 6

Oyuncak GREAT PLANES Sport Float Kit ARF için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES Sport Float Kit ARF 16 sayfaları.

rails and make some shims from leftover ply. Tack glue the

servo tray rails in place again and check the fit of the servo

tray. When satisfied with the fit, use 6-minute epoxy to glue

the rails permanently in place.

8. Mount the servo to the 5/16" x 3/4" x 7/8" [8 x 19 x

22.2mm] basswood blocks, using the hardware supplied

with the servo. Make sure the servo is oriented as shown in

the photo with the servo arm pointing as shown. The edge

of the block should extend past the rear side of the servo

slightly. See the photo at step 10.

9. Position the servo tray as shown and mark the location

of the mounting rails.

10. Use 6-minute epoxy to glue the basswood blocks to

the servo tray, with the servo attached. The servo should be

centered between the lines marking the location of the rails.

After the epoxy has cured, install the tray into the opening

in the float and make sure it fits properly.

Assemble the Water Rudder

1. If your water rudder is already assembled, proceed to

step 7. Otherwise, refer to the above photos as you

assemble the water rudder.

2. Drill two 1/8" [3.2mm] holes in the aluminum water

rudder at the locations shown in the above photo.

3. Drill and tap a 2-56 hole in the nylon rudder post at

the location shown in the above photo. Install the 2-56 x 1/2"

[12.7mm] screw in the hole.