GREAT PLANES YAK 55 Kullanım Kılavuzu - Sayfa 9

Oyuncak GREAT PLANES YAK 55 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GREAT PLANES YAK 55 16 sayfaları. 3d ep with flightflex

Set Up the Radio System

❏

1. Secure a 6" [152mm] extension to each of your aileron

servos with tape or heat-shrink tubing. Use the strings in the

wings to pull the leads through into the cockpit area.

❏

2. Use hot-melt glue to glue the servos into the wing

cutouts with the output shafts forward.

❏

3. Secure 12" [305mm] extensions to your elevator and

rudder servos using tape or heat shrink tubing. Use the string in

the fuselage to pull both servo leads into the cockpit area.

❏

4. Glue the tail servos into the cutout in the fuselage with

hot-melt glue. Both servos should have their output shafts

toward the front of the airplane, and the lower servo should

project out the left side of the plane, while the upper servo

projects out the right side.

❏

5. Cut a slot in the left elevator half in the location shown.

The front of the slot is just aft of the carbon tube. The plane

is shown here upside down.

❏

6. Cut a slot in the rudder in the location shown. The front

of the slot is even with the start of the hinge bevel on

the rudder.

❏

7. Cut a slot in each aileron in the location shown. The

front of the slots are even with the start of the hinge bevels

on the ailerons.