GREAT PLANES MASTER CADDY Montaj Talimatları Kılavuzu - Sayfa 14
Ölçüm Cihazları GREAT PLANES MASTER CADDY için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. GREAT PLANES MASTER CADDY 15 sayfaları. With auxiliary power station
Sayfayı Yazdır
position these straps wherever you prefer but the farther
apart they are spaced, the better they will hold the fuel
container. Use a #4 x 3/8" sheet metal screw along with
a #4 washer to secure each strap in the holes you just
drilled. Pull the straps snugly around your fuel container
and drill the 5/64" holes on the other side of the MAS-
TER CADDY.
Use the two remaining #4 x 3/8" screws
and #4 washers to secure the fuel container.
FINISHING
It is very important that you apply some type of
finish to your MASTER CADDY. Ifis not finished it
will become dirty and fuel soaked very quickly. There
are three different types of finishes you can apply to your
MASTER CADDY. A clear, natural looking finish, A
stained, natural looking finish, or a painted finish,
CLEAR FINISH - Seal the wood with either poly-
ester resin, coating epoxy or clear polyurethane.
STAINED FINISH - Apply the stain first and then
seal the wood with either polyester resin, coating epoxy
or clear polyurethane
PAINTED FINISH - Fill the wood with a wood
filler. Seal the wood with a light coat of either polyester
resin, coating epoxy or polyurethane. Then, use several
coats of primer to fill the grain completely. Apply your
choice of fuelproof paint but make sure itis compatable
with the primer you used.
©
1. Whichever finish you choose, itisimportant that
you take your time and properly prepare the surfaces to
achieve a nice smooth appearance. Use some wood filler
compound to fill any gaps
in the wood orseams. Remove
all knobs and screws, and disassemble the cradles so that
it is easier to sand and paint the surfaces.
Sand all
surfaces with 400 grit sandpaper before each coat of
paint. Be careful not to sand through to the bare wood
when sanding, especially around the comers.
O
2.
When painting the MASTER CADDY, it is a
good idea to use primer for a base coat. It will help fill
the grain and will give a consistent color to all surfaces.
The mahogany plywood used in this kit can vary in color
quite noticeably, which can make the same color of paint
look like several different colors when applied to wood
that is not primed.
E
SUT
ONE SIDE
FINAL ASSEMBLY
O 1. Useascissors to slit one side of the foam tubing
in a straight line from one end to the other. Cut four
pieces of foam tubing 3-1/2" long and two pieces 4-1/2"
long. Cut a 90 degree notch 1/2" from one end of each
3-1/2" piece as shown in the photo. The notch should be
centered along the lengthwise slit.
O 2. Glue the 3-1/2" long pieces of tubing to the four
cradle halves with C/A glue, and use Acceleratorto speed