Emerge SmartSurge Kullanıcı Kılavuzu - Sayfa 3

Aşırı Gerilim Koruyucu Emerge SmartSurge için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Emerge SmartSurge 4 sayfaları.

Sayfayı Yazdır
Installation of SmartSurge
1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the SmartSurge unit.
3. Plug the SmartSurge unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the SmartSurge where monitoring lights
can be observed.
Installation for Protection for Telephone Line
TELEPHONE
1. Unplug the equipment's telephone cable from the wall jack and plug into the RJ11 "OUT"
on the SmartSurge.
2. Plug the provided telephone cable to the RJ11 jack "IN" on the SmartSurge.
3. Plug the other end of the telephone cable into the RJ11 wall jack.
CAUTION: - Never install telephone wiring during a lightning storm.
- Disconnect telephone line at the network interface before installing the secondary
protector.
- Intended for indoor use only.
Telephone Line Protection clamping voltage 250-350 vdc.
Installation for Protection for Network Cable
1. Unplug the equipment's network cable from the wall RJ45 network jack and plug into the RJ45
"OUT" on the SmartSurge.
2. Plug the provided CAT5 cable to the RJ45 jack "IN" on the SmartSurge.
3. Plug the other end of the CAT5 cable into the wall RJ45 network jack. Your equipment is now
fully protected. Place the SmartSurge where monitoring lights can be observed.
Use the Standard CAT 5 Network Patch cord when using the Network protection RJ45 circuit.
IMPORTANT: The SmartSurge is designed to be compatible with a GFCI (Ground Fault
Circuit Interrupter), however, during plug in the GFCI might trip. Press the reset button to
restart the circuit.
Power Cord
IN
Network Jack/ HUB
GREEN LIGHT
The green light confirms power exists
at the output receptacle.
Power Cord
OUT
IN
OUT
Connected
Equipment with
Network Jack
Phone Wall Jack